EBMM-E使用说明书【DOC精选】.docVIP

EBM5-10E MOBILE BLOCK MACHINE OPERATING PROCEDURES First, the preparatory work before the operation: 1, check whether the abnormalities of all moving parts and the lubrication od components, fastening screws and the lubrication of various parts of refueling point, 2,, check the power situation: Voltage: 380V?0, and the nuturn the power switch, check whether the missing phase. 3, check the hydraulic oily bits, hydraulic oily should be added to 4cm away from the fuel filler is appropriate, manual valve handle should be in the middle (At this point in the unloading sate). 4, state checking motor oil pump motor steering( no oil pressure when the reverse). 5, the system pressure regulation: Start oil pump motor, the valve handle to push down to the fuel tank location, open the pressure gauge switch, adjustable regulator valve rotating handle(rotation handle the pressure adjustment valve in the valve then the rear, clockwise pressure increases, counter-clockwise to reduce) to the system pressure 4-6 Mpa lochknut(new machine factory pressure has been adjusted good). 6, the system unloading: valve handle should be positioned in the middle, pressure gauge index”0~1MPa” unloading at around normal (when factory tune good). 7, toggle valve handle, observe the fuel tank functioning properly, check the mold is pressed between the first position in the mold core is correct. Assess is normal, these are normal, may be ready for production purposes. Second, the production ateps 1, the starting state; A, rose to the highest point on thr mold B, the next model down to the lowest point(ground) C, distributor retreat beneath the hopper and fill material D, filled with brick-marking material inside the silo 2, production and operation A, start the pump motor B, Slide distributor handle, pushing the fabric to the mold box at the top of device while starting vibrator, this time distributor to do a~2moves back and forh in order distributor of raw mate rials to the mold box will be full ofco