AS5000.3-2003---聚合物绝缘电力电缆第三部分：多芯控制电缆精编.docVIP

Australian/New Zealand StandardTM 澳大利亚/新西兰标准TM Electric cables—Polymeric insulated Part 3: Multicore control cables 聚合物绝缘电力电缆 第三部分：多芯控制电缆 This Joint Australian/New Zealand Standard was prepared by Joint Technical Committee EL-003, Electric Wires and Cables. It was approved on behalf of the Council of Standards Australia on 29 November 2002 and on behalf of the Council of Standards New Zealand on 27 November 2002. It was published on 3 February 2003. 本《澳大利亚/新西兰联合标准》由EL-003电线电缆技术联合委员会编制，以澳大利亚标准委员会和新西兰标准委员会的名义分别于2002年11月29日和2002年11月27日获得审批通过，并于2003年2月3日出版。 The following are represented on Committee EL-003: EL-003委员会由下列单位参加： Australasian Railway Association 澳大利西亚铁路协会 Australian Electrical and Electronic Manufacturers Association 澳大利亚电气与电子制造商协会 Australian Industry Group 澳大利亚工业集团 Canterbury Manufacturers Association New Zealand 新西兰坎特伯雷制造商协会 Department of Defence (Australia) 澳大利亚国防部 Department of Mineral Resources N.S.W. 新南威尔士矿产资源部 Electrical Contractors Association of New Zealand 新西兰电气承包商协会 Electrical Regulatory Authorities Council 电气监管机构委员会 Electricity Supply Association of Australia 澳大利亚供电协会 Institution of Engineers Australia 澳大利亚工程师协会 Ministry of Economic Development (New Zealand) 新西兰经济发展部 National Electrical and Communications Association 国家电气与通信协会 Keeping Standards up-to-date 关于标准的更新 Standards are living documents which reflect progress in science, technology and systems. To maintain their currency, all Standards are periodically reviewed, and new editions are published. Between editions, amendments may be issued. Standards may also be withdrawn. It is important that readers assure themselves they are using a current Standard, which should include any amendments which may have been published since the Standard was purchased. 标准是应适时更新的文件体系，反映人们在科学、技术及系统方面取得的进步。为了保持标准的版本最新，所有标准都得定期进行评审并出版新的版本。在刊印不同版本期间，可能还会发行标准的修正内容。标准也可能会被取消。因此，读者使用的版本必须是最新版本，其中应包括在购买标准以来出版的所有修正版本的内容。 Detailed information about joint Australian/New Zealand Standards can be