DIN8187-2-1998滚子链欧洲式第2部分_带紧固垫板的单节滚子链连接尺寸.pdfVIP

--`,,,,-`-`,,`,,`,`,,` DEUTSCHE NORM European type roller chains Part 2: Simple roller chains with attachment plates - Connecting dimensions Aunust 1998 IDIN II 8187-2 ICs 21.220.30 Descriptors: Roller chains, connecting dimensions. Rollenketten, europ?ische Bauart - Teil 2: Einfach-Rollenketten mit Befestigungslaschen - Anschlu?ma?e Inkeeping with current practice instandards publishedby the InternationalOrganizationfor Standardization (EO), a comma has been used throughout as the decimal marker. Dimensions in mm Foreword This standard has been prepared by Technical Committee Stahlgelenkketten of the Normenausschu? Maschinenbau (Mechanical Engineering Standards Committee). Most of the connecting dimensions for attachment plates in this standard are those given in I S 0 606 : 1994. 1 Scope This standard sets out connecting dimensions for simple roller chains as in DIN 8187-1, with angled or straight attachment plates. Roller chains are commonly used for power transmission purposes; plates mounted on roller chains enable further elements to be attached. 2 Normative references This standard incorporates, by dated or undated reference, provisions from other publications. These normative references are cited at the appropriate places in the text, and the titles of the publications are listed below. For dated references, subsequent amendments to or revisions of any of these publications apply to this standard only when incorporated in it by amendment or revision. For undated references, the latest edition of the publication referred to applies. DIN 8187-1 European type roller chains - Simple, duplex and triplex chains IS0 606 : 1994 Short-pitch transmission precision roller chains and chain wheels 3 Dimensions and designation The designs shown in this standard are for illustrative purposes only, but the dimensions of the plates shall be as specified. All other specifications and dimensions shall be as in DIN 8187-1. Orders shall specify the arrangement of the plates (on