具有温度补偿电容之定电压控制LED构装模组.docVIP

逢 甲 大 學 自動控制工程學系碩士班 碩 士 論 文 An LED Packaging Module with a Temperature Compensated Capacitor for Constant Voltage Control 指導教授：鄒慶福 生：黃 中華民國一百零年月　　 從進入微機電系統創意科技實驗室開始，從待人處事的態度，事情處理的節奏，對新事物新觀點的開拓，自主目標的追求，這些都是我那脫序且僵化的思維所面臨到的衝擊。我非常感謝　鄒慶福老師對我以及我的研究甚至對我在做的每件事情都能有獨特的看法與建議，儘管當下也許有不解與疑問，但是真正去執行的過程以及得到最後的成果以後，學到的東西已經不是侷限在表面上看得到的結果，並且期待下次能更為精進。我同時非常感謝　洪三山老師對我於研究上、課業上以及專業上的輔助，對每件事情都認真執行的工程思維也是我必須學習的。以及感謝許煜亮老師與賴騰憲博士對於我論文與研究認真的指點與建議。 黃小明　僅誌 中華民國一百零四年九月 摘　　要 Abstract As the epitaxial process for the manufacture of light emitting diodes (LED) and packaging technology has been continuously improved, the lifetime and luminous efficiency of LEDs have increased greatly. Due to the thermal energy affects on the electrical property of LED, its driving power requires constant current control to adjust brightness. However, this approach needs extensive electronic parts to conduct signal processing, which will decrease the reliability and lifetime of LED. Moreover, as the packaging volume increases, manufacturing costs become relatively higher. In order to address these problems, a silicon-based LED packaging module with a temperature compensating capacitor is proposed, which can provide stable luminous efficiency, and be applied to the constant voltage driving mode. The packaging module uses 3D stacking technology to integrate LED and capacitor on a silicon micromachining substrate. The inductor is used for electrical impedance with capacitor, when supplying a constant voltage with periodical switch mode to LED. Based on this configuration, the temperature variation that generated by the LED can directly changes the capacitance in a series driving circuit; thereby, compensating the resistance variation in the LED to stable the driving current. Thus, a miniaturized, low-cost, constant voltage controllable LED lighting module can be achieved. Keywords: LED, Temperature compensating capacitor, 3D stacking technology, Constant voltage control. 目　　錄誌　　謝 i 摘　　要 i