1_1基本拧紧技术概要.pptVIP

* * * * * * * PVT is provided by Nyloc bolts and non-circular bolts for example. The reason to use these bolts is to prevent the screw from unscrewing itself, even if the torque/friction under bolt head is lost. Often used on safety critical joints, for example seatbelts. The PVT does not contribute to the clamping force!! If we have 10 Nm PVT and a final target of 20 Nm only 10 Nm will contribute to the clamping force. This might require a compensation, to add the PVT to the final target. * * * * * Low grade fasteners ”yield” at a lower % of the ultimate failure load than high grade fasteners. Beyond the yield point, the fastener is permanently elongated. Each time the fastener is loaded beyond its yield point it is further elongated. This results either in total loss of clamping force or the failure of the fastener. * * * If you increase the quality of the bolt you can decrease the size of the bolt. Any questions? Thanks for your attention! * 改变摩擦力 – 加润滑friction change-lubrication 螺纹里的润滑lubrication * 扭矩和夹紧力的关系torque and clamp force 50 % 20 % 30 % 50% 30% 螺纹里加润滑lubrication 螺纹副摩擦力Friction in the threads 夹紧力Clamp Force 螺栓头摩擦力Screw head friction * 摩擦力减小会导致...friction decrease 50 % 20 % 30 % ...过拧！Over clamp force * 改变摩擦力 – 生锈的螺栓friction change-rusty bolt 生锈的螺栓rusty bolt * 50 % 0 % 50 % 50% 50% 生锈的螺栓rusty bolt 螺纹副摩擦力Friction in the threads 夹紧力Clamp Force 螺栓头摩擦力Screw head friction 扭矩和夹紧力的关系torque and clamp force Prevailing torque compensation Angle / Time Torque Prevailing torque Prevailing torque compensation Target torque 扭矩Torque (Nm) 角度Angle (degrees) 啮合点Snug level 硬连接Hard Joint 拧紧到目标扭矩角度小于30°Tightening angle below 30° 目标Target 30 硬连接Hard joint 软连接Soft Joint 拧紧到目标扭矩角度小大于720° Tightening angle above 720° over 720 软连接Soft joint 扭矩Torque (Nm) 角度Angle (degrees) 啮合点Snug level 目标Target Real joints 很少连接是硬连接Very few joints are below 30° 很少连接是软连接Very few joints are above 720° 绝大多数是中性连接Most joints are between 30 and 720° 为什么这样定义Why do we have these definitions? 硬连接Hard Join