technicalrequirementforenvironmentalproducts.docVIP

Technical Requirement for Environmental Products The Certificable Technical Requirement for Environmental Labelling Products Metal welding Gas HBC 13－2002 1 Scope This technical requirement specifies definition, basic requirements, technical contents and test method for environmental labelling products of metal welding gas. This technical requirement shall apply to hydrocarbon gases with function of metal welding, incision, heating or new metal welding gases use additive in the hydrocarbon gases. 2 Standards cited Provisions in the following standards are cited in this technical requirement, and therefore form the provisions of the standard. When this technical requirement is published, all of the version of these standards are valid. All of these standards shall be revised, and parties use this technical requirement should take into consideration the possiblity of using the latest edition of the following standards. GB 9052.1－1998?Liquefied petroleum gas of oil and gas field GB 9448－1999?Safety in welding and cutting GB 12206－1990?Method of testing for calorific value of gas in urban areas GB 17673－1999?Welded steel cylinders for liquefied propylene and propane gases GB 18583－2001 Indoor decorating and refurbishing materials--Limit of harmful substances of adhesives SH 0232－1993?Test method for Corrosion of Copper Strip in Liquified Petroleum Gas 3 Basic requirements 3.1 Quality of main media of product (excluding additives) should accord with requirement in GB 9052.1-1998. 3.2 Safety performance in using the products should accord with requirement in GB9448-1999. 3.3 Pollutant emission of the company should conform with pollutant emission standards nationally or locally. 4 Technical contents 4.1 Acetylene gas produced by method of calcium carbide process should not be used in the products. 4.2 Benzene content in additive of products should be = 5g/kg, total contents of toluene and xylene should be = 200g/kg. 4.3 Flame