cac设计要求.pptVIP

TTHE JAN-OLOF GUNDBERG Charge Air Pipes Hose Clamp ConnectionsDesign Guidelines Dimensions * 1 Dimensions hose for screw clamp 9 mm wide Length In order to create a appropriate overlap between pipe and hose lengths have to fit 100% to neck length and be calibrated in sufficient lenght Wall Thickness The chosen wall thickness is depending on rubber material and hose construction. Wall thickness in the spigot area should normally be 4 mm Tolerances Press fit according 0 / -1.3 compared to spigot diameter Ds Calibration of hose ends Calibration of hose end is mandatory to reduce toleranc