HBL5006-LEDShunt.pdfVIP

HBL5006 Series LED Shunt The HBL5006 Series are electronic shunts which provide a current bypass in the case of LEDs going into open circuit. LEDs are by nature quite fragile when subjected to transients and surge conditions. There are also many cases where high reliability of the LED lighting must be maintained such as in headlights, lighthouses, bridges, aircraft, runways and so forth. In these cases the low cost addition of the shunt device will provide full assurance that an entire string of LEDs will not extinguish should one LED fail open. The shunt device is also applicable to other loads where circuit continuity is required. The devices are designed to be used with LED string currents from 50 to 350 mA. Features ? Protection for the Following IEC Standards: IEC 61000?4?2 (Level 4) ISO 10605 ? Low ESD Clamping Voltage ? Automatically Resets Itself if the LED Heals Itself or is Replaced ? ON?State Voltage Typically 1.1 V ? OFF?State Current less than 1.0 mA ? SZ Prefix for Automotive and Other Applications Requiring Unique Site and Control Change Requirements; AEC?Q101 Qualified and PPAP Capable ? These Devices are Pb?Free and are RoHS Compliant Typical Applications ? LEDs where Preventive Maintenance is Impractical ? LED Headlights in Automobiles ? Automotive LED Applications ? LEDs with High Reliability Requirements ? Crowbar Protection for Open Circuit Conditions ? Overvoltage Protection for Sensitive Circuits MARKING DIAGRAMS SOD?323 CASE 477 1 2 HD M SOD?523 CASE 502 12 56 M SOD?923 CASE 514AB 1 LD M 2 XX = Specific Device Code M = Date Code HBL5006 Control Circuit ESD 1 + HBL5006 ? 2 Apply heat sinking to pin 2 ORDERING INFORMATION See detailed ordering and shipping information in the package dimensions section on page 5 of this data sheet. ? Semiconductor Components Industries, LLC, 2014 August, 2014 ? Rev. 0 1 Publication Order Number: HBL5006/D HBL5006 Series MAXIMUM RATINGS Rating On?State Current, (TA = 25°C) (Note 2) SOD?323 (Note 1) SOD?323 (Note