MCSS安装参数答案.docVIP

MCSS PARAMETERS SPEC-90, E311 EEPROM SETTING MANUAL VER. 2.5 M -- 2 -- 3 [ INST = 1 ] Top floor job top floor number ( = bottom floor+53 ) 最高层 Bottom floor 0 bottom floor number ( = 0 ) 最底层 Country AJG 1 0 = NAO, 1 = JAPAN, 2 = ETO 控制型号。 ENABLE ADO NY (0) 0 = DISABLE, 1 = ENABLE 是否允许提前开门 ENABLE RELEVEL 1 0 = DISABLE, 1 = ENABLE 是否允许再平层 ADV BRK LIFT 0 0 = DISABLE, 1 = ENABLE ( NOT USED ) 是否允许提前打开抱闸 DBSS PARITY 0 0 = ODD, 1 = EVEN CAR NON START 20 s Max, permissible time for detecting door zone of next floor when running ( not used ) 经过两个插板允许的最大运行时间。 MAN. DECEL TIME 0 ( not used in Japan ) No. of DZ in 1LS 1 Number of door zone vane in 1LS zone 在1ls内，门区插板的数量 No. of DZ in 2LS 1 Number of door zone vane in 2LS zone 在2ls内，门区插板的数量 Abs. overspd % NOR 110% Ultra over-speed detection permissible % at normal running 正常运行期间，允许的最大超速。 Abs. overspd % INS 130 % Ultra over-speed detection permissible % at inspection running 检修运行期间，允许的最大超速。 Abs. overspd % REC 150 % Ultra over-speed detection permissible % at recover running 自平层运行期间，允许的最大超速。 Abs. overspd % REI 150 % Ultra over-speed detection permissible % at reinitialize running 复位运行期间，允许的最大超速。 Abs. overspd % JPSDO 120 % Ultra over-speed detection permissible % at terminal floor running on JPSDO Track err % NOR 25% Actual speed error permissible % at normal and reinitialize running 正常运行和复位运行时，允许和实际速度的误差。 Track err % INS 50% Actual speed error permissible % at inspection and recover running 检修运行时，允许和实际速度的误差。 Track err % LOW 255 % Actual speed error permissible % at relevel and learn running 再平层运行和自学习运行时，允许和实际速度的误差。 NTSD percent 97% Permissible speed at 1LS / 2LS detection ( % of Normal speed ) 1ls，2ls动作时电梯速度大于该设定值时，执行强迫减速功能（正常速度%） ETSD percent 94 % ETSD relay control speed ( % of Nor. speed ) ETSD继电器动作速度（正常速度%） Enable ETSD 1 0 = disable, 1 = enable ( relay fault detection ) 是否有ETSC功能。0=不允许，1=允许 PTR drop delay 10ms Timing for prepare-to-run drop after brake cut-off 0 : spec-90 /