小電流接地系统单相接地保护选线方案的研究.docVIP

  • 4
  • 0
  • 约1.3万字
  • 约 27页
  • 2017-03-27 发布于上海
  • 举报

小電流接地系统单相接地保护选线方案的研究.doc

小電流接地系统单相接地保护选线方案的研究

论文 对小电流接地系统单相接地保护选线方案的研究 学科(专业):电力系统及其自动化 Title:Project of line selection for small current grounding system of single-phase grounding protection research Speciality:Applicant:Xiong Shuwei Supervisor:Since small current grounding operation and maintenance personnel in ensuring the safety of over-voltage levels, equipment insulation levels, and there exist many economic advantages, it has been applied to low-voltage power grid in China. In actual production, the low-pressure line failure, more than 70% are single-phase ground fault, therefore, to find a select line of high accuracy of the protection device, still has a very important theoretical and practical value. This article mainly current system of small single-phase line selection method of analysis of the small current grounding fault transient algorithm and secure algorithm, and analyzed the wavelet analysis and its electric power system. Finally a simulation study. KEY WORDS: system with non-effectively earthed neutral;single-phase-to-ground fault;fault line selection; TYPE OF THESIS:application 目 录 摘 要 I ABSTRACT III 目 录 V 1绪论 1 1.1 课题研究背景与意义 1 1.2 课题研究现状 2 1.3 论文的主要内容 3 2小电流接地系统单相接地选线方法分析与探讨 5 2.1小电流接地故障稳态算法 5 2.1.1零序电流幅值比较法 5 2.1.2零序电流方向法 5 2.1.3谐波法 6 2.1.4零序电流有功分量法 6 2.1.5负序电流法 6 2.1.6零序导纳法 6 2.2小电流接地故障暂态算法 7 2.2.1暂态零序能量法 7 2.2.2暂态零序相位法 7 2.3基于现代信号处理技术的故障选线算法 7 3 多判据信息融合选线方法 9 3.1引言 9 3.2选线原理选择 9 3.2.1中性点不接地方式下选线原理选择 9 3.2.2谐振接地方式下选线原理选择 9 3.3 综合选线方案 10 3.4模糊选线 10 4 小电流系统选线问题 12 4.1检测信号原因分析 12 4.2误判原因分析 12 4.3本章小结 13 5结论与展望 15 致 谢 17 参考文献 19 声明 1绪论 课题研究背景与意义 电力系统常用的系统接地方式有四种:中性点直接接地,中性点经电阻接地,中性点不接地和中性点经消弧线圈接地。而上述的四种方法可归结为三类接地系统:中性点直接接地或经一低阻抗接地的系统,这种系统称为有效接地系统;不接地或经高阻抗接地的系统,这种系统称为非有效接地系统;经消弧线圈接地的系统,称为消弧线圈接地系统也称谐振接地系统。 在我国城乡3~66kV配电网络中,大多数是中性点非直接接地系统。此类系统零序阻抗很大,通常为正序阻抗的4~5倍,因此发生单相接地短路时,流过接地点的故障电流较小,所以称其为小电流接地系统。小电流接地系统包括中性点不接地系统(NUS)、中性点经消弧线圈接地系统(NES,也称为谐振接地系统)及中性点经高阻接地系统(NRS)[1]。 在中性点直接接地系统中,一旦某条出线发生单相接地短路故障,就会产生很大的单相接地故障电流,从而启动保护装置动作跳闸。由于配电线路绝大部分故

文档评论(0)

1亿VIP精品文档

相关文档