最新10月CCNA題库word版1~100题.docVIP

QUESTION 1 When you are logged into a switch, which prompt indicates that you are in privileged mode? A. % B. @ C. D. $ E. # QUESTION 2 Which command shows system hardware and software version information? A. show configuration B. show environment C. show inventory D. show platform E. show version QUESTION 3 Cisco Catalyst switches CAT1 and CAT2 have a connection between them using ports FA0/13. An 802. 1Q trunk is configured between the two switches. On CAT1, VLAN 10 is chosen as native, but on CAT2 the native VLAN is not specified.What will happen in this scenario? A. 802.1Q giants frames could saturate the link. B. VLAN 10 on CAT1 and VLAN 1 on CAT2 will send untagged frames. C. A native VLAN mismatch error message will appear. D. VLAN 10 on CAT1 and VLAN 1 on CAT2 will send tagged frames. QUESTION 4 Which command would correctly configure a serial port on a router with the last usable host address in the 2/29 subnet? A. Router(config-if)# ip address 8 40 B. Router(config-if)# ip address 9 24C. Router(config-if)# ip address 3 48 D. Router(config-if)# ip address 9 48 E. Router(config-if)# ip address 3 48 F. Router(config-if)# ip address 8 48 QUESTION 5 The network default gateway applying to a host by DHCP is 3/28. Which option is the valid IP address of this host? A. 5 B. 7 C. 0 D. 2 E. 4 QUESTION 6 Which two addresses can be assigned to a host with a subnet mask of ? (Choose two.) A. B. C. 55 D. 55 E. QUESTION 7 The network administrator has asked you to check the status of the workstations IP stack by pinging the loopback address. Which address would you ping to perform this task?A. B. C. D. QUESTION 8 Workstation A has been assigned an IP address of 4/28. Workstation B has been assigned an IP address of 00/28. The two workstations are connected with a straight-through cable. Attempts to ping between the hosts are unsuccessful. What two things can be done to allow communications between the hosts? (Choose two.) A. Replace the stra