ETA6003 带路径管理开关充电.pdf

ETA6003 www.ETA Outperform with Efficiency Proprietary Information DO NOT Distribute 1 2.5A, 3MHz Switching Charger with Dynamic Power Path Management DESCRIPTION ETA6003 is a switching Li-Ion battery charger with dynamic power-path control and input current limiting. When a battery is connected, depending on the battery voltage, the DC-DC switching regulator either pre-conditions, fast-charges the battery or just regulates a system voltage (VSYS) to a preset voltage. It does not require an external sense resistor for current sensing. The charging current is determined by programming ISET1 or ISET2 pin, depending on the state of the USB_DET. If USB_DET is low, indicating an valid AC adapter input is present, the charge current is set by ISET1; otherwise, it is set by ISET2. When the battery voltage reaches the termination voltage i.e. 4.2V, the charging path disconnects SYS to BATT. The ETA6003 also includes a dynamic power path when the SYS load current exceeds current limit of the DCDC regulator internally set, the SYS voltage falls below VBATT, ETA6003 turns on the power-path to supplement the system load through the battery. FEATURES ? Switching Charger with Power Path Management ? Up to 95% DC-DC Efficiency ? 50mΩ Power Path MOSFET ? Up to 2.5A Max charging current ? Instant on with a dead Battery or no Battery ? No battery detection ? No External Sense resistor ? Programmable USB and AC IN Charging Current APPLICATIONS ? Tablet, MID ? Smart Phone ? Power Bank ORDERING INFORMATION PART PACKAGE PIN TOP MARK ETA6003Q3Q QFN3X3-16 ETA-42 - Product Number YWWPL - Date Code TYPICAL APPLICATION 2A Switching Charger with Dynamic Power Pat ETA6003 www.ETA Outperform with Efficiency Proprietary Information DO NOT Distribute