JDM B15(铸铁件一般要求中英).pdf

mk:..:.’ John Deere Standard APPROVED FOR SUPPLIER DISTRIBUTION I JDM B15 General Requirements for Iron Castings (Applies to Parts Adopted TABLE OF CONTENTS SCOPE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . BASIC REQUIREMENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TOLERANCES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . QUAbTY ASSURANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . REFERENCES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . After 30 June 1994) Issued: Mar 94 Revised: Term Code: Design Control: DT Page 1 oi 14 Supersedes: John Deere standards are intended for use by Deere Company, Its dw.tons and subsidiaries Suppliers who rely on them m furnishing products to or for the benefit of the Company must determine that they are in possession of the latest version Distribution of the standards to parties other than John Deere Supphers, whether with or without charge. are for information only and Deere Company disclalms all responsibility for results attributable to the application of or compliance with such standards The Company makes no presentation, express or implied. that mnformity ensures comphance with applicable law or other rules or regulations Further, those who are m receipt of and elect to use the standards: agree to assume the responsibhty for compliance wim patents, as weli as potential patent infringement Deere Company Engineering Standards Department, John Deere Road Mine Iliinois 61265 Unpublished—All rights reserved under tne czrpynght laws. JDM B15 I APPROVED FOR SUPPLIER DISTRIBUTION I 1. SCOPE JDM B15 specifies dimensional castings of gray (flake graphite), tolerances and other general requirements applicable to sand molded mmpacted graphite, ductile (spheroidal graphite), austempered ductile, malleable, and white iron. All requirements of JD