PAC8000与IFIX通讯说明.pdf

GE FANUC - CONFIDENTIAL GE Fanuc Automation makes no representation or warranty, expressed, implied, or statutory with respect to, and assumes no responsibility for the accuracy, completeness, sufficiency, or usefulness of the information contained herein. No warranties of merchantability or fitness for purpose shall apply Page 1 of 21 Integrating SafetyNet With iFIX This Application Note describes the process required to set up OPC communications between an SafetyNet node and a PC running iFix Alan Blight Global Technical Manager (Infrastructure) May 2008 Keywords: MOST, SafetyNet, iFix, OPC Application Note No: H- GE FANUC - CONFIDENTIAL GE Fanuc Automation makes no representation or warranty, expressed, implied, or statutory with respect to, and assumes no responsibility for the accuracy, completeness, sufficiency, or usefulness of the information contained herein. No warranties of merchantability or fitness for purpose shall apply Page 2 of 21 TABLE OF CONTENTS TABLE OF CONTENTS2 REVISION HISTORY2 BLOCK DIAGRAM OF CONTROL ARCHITECTURE:3 BILL OF MATERIALS: 4 Hardware: 4 Software: 4 GENERAL DESCRIPTION: 4 The OPC Server4 Configuring Universal Server Limited Edition6 Creating the Safety Application6 Check the points in the MOST OPC Server10 Configuring the tags in iFix12 Operation of the Safe_D Tag20 REVISION HISTORY Version Date paragraph Remarks Author 0.01 31 May 2008 Draft submitted for review Alan Blight GE FANUC - CONFIDENTIAL GE Fanuc Automation makes no representation or warranty, expressed, implied, or statutory with respect to, and assumes no responsibility for the accuracy, completeness, sufficiency, or usefulness of the information contained herein. No warranties of merchantability or fitness for purpose shall apply Page 3 of 21 BLOCK DIAGRAM OF CONTROL ARCHITECTURE: GE FANUC - CONFIDENTIAL GE Fanuc Automation makes no representation or warranty, expressed, implied, or statutory with respect to, and assumes no responsibility for the accuracy, completen