STEVAL-ILL009V3;中文规格书,Datasheet资料.pdf

Data Brief For further information contact your local STMicroelectronics sales office. November 2007 Rev 1 1/4 4 STEVAL-ILL009V3 OSRAM OSTAR? projection LED board Features ■ Outstanding brightness and luminance due to pure surface emission and low Rth prepared for additional optics ■ Dominant wavelength: 617 nm amber (red) ■ Dominant wavelength Color 2: 525 nm true green ■ Dominant wavelength color 3: 464 nm blue ■ Viewing angle at 50 % IV : 120 ° (lambertian emitter) ■ Light emitting surface: (typ.) 2.1 x 2.1 mm2 ■ Technology: InGaAlP thinfilm amber (red) ■ Technology color 2: ThinGaN true green ■ Technology color 3: ThinGaN blue ■ Luminance: 18*106 cd/m2 amber (red) ■ Luminance color 2: 14*106 cd/m2 true green ■ Luminance color 3: 3.5*106 cd/m2 blue ■ Efficacy color 2: 86.0 lm/W true green ■ Efficacy color 3: 17.0 lm/W blue ■ ESD-withstand voltage: up to 2 kV acc. to JESD22-A114-B Description This board should be connected through the 30- pin connector to the STEVAL-ILL009V1 control board to be able to show the light effect with the board. The OSTAR? projection module, used as light source, has a maximum forward current of 700 mA. The NTC resistor is directly assembled on the OSTAR? module. As the power of the module is above 10 W, the heatsink is used to keep the temperature in range. The biggest advantage of the OSTAR? module is that red, green and blue LEDs are in the same package, very closely assembled and therefore the color effect is better than with three separate LEDs. STEVAL-ILL009V3 / Board schematic STEVAL-ILL009V3 2/4 1 Board schematic Figure 1. Schematic R_diss = U/I = 06 / 0.7 = 0.85 = 0.75 Ohms U_r = Us - Uf_red_max = 4 - 3,4 = 0.6V R2 = R3 = 1.5 Ohms R2 || R3 = 0.75 Ohms 5V 4k7 NTC 1.263V for 72?C R_ntc (72?C) = 1588 Ohms R3 1.5 R4 4k7 1 2 3 4 5 6 7 8 9 1 0 CONNECTOR1 ICC R1 0 R 1 1 R 1 2 G 1 a 3 G 1 a 4 G 1 b 5 G 1 b 6 B 1 7 B 1 8 R 2 9 R 2 1 0 G 2 a 1 1 G 2 a 1 2 G 2 b 1 3 G 2 b 1 4 B 2 1 5 B 2 1