静电防护程序文件.pdfVIP

ESD Control Procedure 防静电控制程序 SOP7-22 Rev.: 0 COMPANY RESTRICTED Originator: Shuaiyu He Date: 2009-4-23 Page: 1 of 7 ESD Control Procedure 防静电控制程序 0. Survey of Changes New Date Related C.P. # Rev # Issued by Change Description 2009-4-23 PSTX-CP-2009009 0 Shuaiyu He First issue 1. Contents\ 2. Scope and Application (适用范围) 3. Introduction (简介) 4. Definitions and Abbreviations (定义和缩写) 5. Responsibilities（职责） 6. Procedure（程序） 7. Interacting Procedure（参考文件） 8. Support Form (记录) 9. Flow chart of Procedure(流程) 2. Scope and Application This procedure is applicable for Flex Power 2 Co. Ltd. /本程序适用于伟创力电源 2。 3. Introduction To define a procedure that establishes the requirement for the ESD prevention, protection, monitoring and control to avoid the ESD sensitive material damage from electrostatic discharge (ESD). 建立关于静电预防，监督及控制体系程序。以避免静电释放对静电敏感材料/元件造成损坏。 4. Definitions and Abbreviations 4.1 ESD-Electro Static Discharge, the transfer or movement of charge between objects that are at different electrical potentials by direct contact or induced by electrostatic field. ESD-静电释放，是指通过直接接触或静电场感应的方式，在不同电势差物体间的电荷转移或移动。 4.2 Volume Resistivity – It’s used to measure and analyze the homogeneous material, it’s measured and expressed in ohm·cm 体积电阻率 – 用来测量和分析均质的材料, 依欧姆·厘米为单位 4.3 Surface Resistivity – It is used to measure and analyze the surface-finish material. It’s measured and expressed in ohms / sq. 表面电阻率 --用来测量和分析表面处理的材料,依欧姆/平方为单位。 4.4 ESDS- Electrostatic Discharge Susceptibility (Sensitivity): The ESD level that causes component failure. ESDS-致使元器件失效的 ESD 水平(即 敏感度)。 4.5 Material type 材料类型 4.5.1 Antistatic Material (Low charging material): the material that used to prevent / inhibit the generation of the Triboelectric Charge; or the material that only generate less than 200V Triboelectric voltage; it has no requirement about surface resistivity and volume resistivity . 抗静电材料(低带电性材料) – 能抑制摩擦生电的材料;摩擦电压在 200V 以下的材料;防静电材料没有表面电阻率或体