屋顶花园网架中庭毕设汇编.docx

含有采光中庭的，顶部为网架的毕设本科毕业设计说明书题目：山东三齐能源有限公司科研综合楼（方案九）院（部）：土木工程学院专业：土木工程班级：土木XXX姓名：XX学号：2001XXXXXX指导教师：XXXXXXX完成日期：XXXXXXXXX正反面打印才有该页摘 要 本文为“三齐”公司拟建的一幢“科研综合楼”。建筑所在场地地形平坦，场地西、北侧为工业园内道路，南侧为绿地。该楼建筑面积约为5300㎡，而且根据功能要求该楼需布置采光中庭约600㎡，并兼作室内展厅、休息厅、中庭内设观光电梯1部。设计建筑为4层，层高为3.6㎡，四层屋面设计为屋顶花园。结构型式为框架结构，采光中庭为网架结构。本文建筑设计部分，根据综合楼要求房屋数量及面积进行建筑平面设计；网架设计部分，根据中庭面积，选取网格尺寸，并进行网架、节点、支座的计算，最后根据计算结果，绘制网架施工图；框架设计中选取一榀主框架进行截面设计及配筋计算，楼板采用弹性理论设计，基础采用柱下独立基础，根据计算结果，按照相应的构造要求，绘制了结构施工图。关键词：科研综合楼、建筑设计、结构设计、施工设计、网架设计Designation for a Office Building （Scheme Three）ABSTRACTSanQi company intends to in industrial park built a building research complex, tomeet the enterprises to improve working conditions and requirements (see Figure 2 for thebase). The terrain is flat, the site is west and north is the Industrial Park Road, and thesouthside is green space. The building area of about 5300 square meters, up and down floating10% - 20%, the main floor, room type and quantity requirements see Schedule otherwise,according to the functional requirements of the building arrangement of lighting atrium about 600 square meters and doubles as an indoor exhibition hall, rest hall, atrium equipped with sightseeing elevator 1, building layers: layer 4, the height of 3.6-3.9 square meters, with a total height control in 24m below, four layer roof design roof garden, structure type: the main frame structure atrium grid structure.The design part of the design grid, according to the atrium area, select the grid size, and the grid, nodes, bearing calculation, and finally according to the results of the calculation, drawing the construction plans. The framework design of selecting a main frame and a floor section design and reinforcement calculation. According to the framework of the layout of the components to determine the size of the components, the dead load, live load and wind load statistics. Then carries on the internal force combination analysis, discovers the most disadvantageous one group of internal forces, carries on the