A320 EACM message RESET CB.pdf

ECAM WARNING / SYSTEM RESET 1 21 – AIR CONDITION NOTE: reset C/B′s during 10 sec, at least, unless otherwise specific ECAM WARNING SYSTEM RESET AIR PACK 1(2) FAULT or OVHT or OFF PACK 1 + 2 FAULT PACK 1(2) REGUL FAULT OVHT temp’s Pack outlet temp. ≥ 95 C Pack compares. Outlet temp. ≥ 26 C FAULT LIGHT goes out when OVHT disapears For all of these ECAM WARNING’s (FAULTs) PACK 1 and 2 OFF. After 30 sec. reset C/B’s during 2 min Pack 1→ X21, X22, Y18, Y19 Pack 2→ W21 W22, Y20, Y21 AUTO TEST 30 sec. PACK 1 and 2 ON FWD CRG VENT FAULT (if installed) AFT CRG VENT FAULT (if installed) C/B’s: C7, T22 AUTO TEST 30 sec. C/B’s: C7, S22 AUTO TEST 30 sec. COND CKPT (FWD CAB) (AFT CAB) (FWD CRG) (if Installed) DUCT OVHT AFT CRG DUCT OVHT (if Installed) OVHT Temp: Duct Temp. ≥ 80o C FAULT LIGHT goes out when Duct temp.70o C and HOT AIR P/B reseted HOT AIR FAULT Walt 3 min. after PACK’s ON before HOT AIR P/B be reseted. IF UNSUCCESSFUL, reset: C/B’s: V17, V18, V19, V20 AUTO TEST 36 sec. TRIM AIR SYS FAULT If the warning and the message TRIM AIR HI PR are triggered when all Trim Air Valves are closed (during the first 30 sec. after the packs are selected ON or In flight If all zones heating demands are fulfilled), disregard them. If not: Reset HOT AIR P/B IF UNSUCCESSFUL reset: C/B’s: V17, V18, V19, V20 AUTO TEST 36 sec. ZONE REGUL FAULT PACK 1 and 2 0FF. C/B’s: V17, V18, V19, V20 AUTO TEST 36 sec. PACK 1 and 2 ON. Note: reset with engines running may triggered the msg. ENG 1 (2) FADEC, in STATUS page. L + R CAB FAN FAULT LAV + GALLEY FAN FAULT C/B’s: LH → X18, X20 RH → W18, W20 C/B’s: U19, U21 2 21 – AIR CONDITION (Cont.) NOTE: reset C/B′s during 10 sec, at least, unless otherwise specific ECAM WARNING SYSTEM RESET FWD CRG ISOL VALVE ( installed) AFT CRG ISOL VALVE (if installed) FWD CRG HEAT FAULT (it installed) AFT CRG