arp命令详解教程.docVIP

arp命令详解 C:\Documents and Settings\Adminiarp /? Displays and modifies the IP-to-Physical address translation tables used by address resolution protocol (ARP). ARP -s inet_addr eth_addr [if_addr] ARP -d inet_addr [if_addr] ARP -a [inet_addr] [-N if_addr] -a Displays current ARP entries by interrogating the current protocol data. If inet_addr is specified, the IP and Physical addresses for only the specified computer are displayed. If more than one network interface uses ARP, entries for each ARP table are displayed. -g Same as -a. inet_addr Specifies an internet address. -N if_addr Displays the ARP entries for the network interface specified by if_addr. -d Deletes the host specified by inet_addr. inet_addr may be wildcarded with * to delete all hosts. -s Adds the host and associates the Internet address inet_addr with the Physical address eth_addr. The Physical address is given as 6 hexadecimal bytes separated by hyphens. The entry is permanent. eth_addr Specifies a physical address. if_addr If present, this specifies the Internet address of the interface whose address translation table should be modified. If not present, the first applicable interface will be used. Example: arp -s 157.55.85.212 00-aa-00-62-c6-09 .... Adds a static entry. arp -a .... Displays the arp table. 显示和修改IP到物理地址转换表的使用 地址解析协议（ARP）。 地址解析协议- ? inet_addr eth_addr [if_addr] 地址解析协议三维inet_addr [if_addr] 地址解析协议- 1 [inet_addr] [氮if_addr] - a显示当前ARP项由目前的审讯 协议数据。如果inet_addr指定的IP和物理 因为只有指定的计算机地址显示。如果 多个网络接口，使用每个地址解析协议阿普项 表中显示。 接枝同- 1。 inet_addr指定Internet地址。 氮if_addr显示为网络接口的ARP项指定 由if_addr。 - d