边缘保护条E_edge_protectors.pdfVIP

Edge protectors Edge protection profiles simplify the finishing of edges. They eliminate preparatory and follow-up work, neutralize respectively cover sheet metal edges. Furthermore, their decorative effect is often desired. The edge protectors consist of a U-shaped metal base, either a steel strip or wire body, jacketed with PVC or rubber. Those guarantee a tight grip on the edge, even if radii or bends have to be covered. In some profiles, the clamping effect is heightened by PVC lips incorporated into the PVC jacket. The edge protectors are pressed by hand or with a rubber or thermoplastic hammer onto the edge. Glues or special attachment aids are not required, installation is simple and quick. Manufacturing tolerances PVC according to DIN 16941 3B Tolerances of custom length based upon DIN ISO 3300-L3/16941 4B Introduction Minimum bending radii Please note that the minimum bending radii indicated are to be considered as guidelines which, depending on the material, clamping range and application of the profile used, may vary. a d b c All profiles shown can be transformed into custom lengths, frames or rings. Different colours or materials such as food compatible, flame-resistant and self-extinguishing qualities upon request. Edge Protectors 14 Issue 03/03 PVC with embedded steel base strip Design Article reference Colour Clamping Sales unit Bending range [mm] [m] radius [mm]