两种不同牌号800 MPa级高强钢焊接性试验比较.pdfVIP

遣尊. ~ Vol43 No.10 鹏 4H器事 10M 因.ectric Weldiog Macbine 仇t却13 2013 年10 月 i两两种种4:不不不不~， I罔罔牌号号R 888i(oo0:ooooi 焊接性试验比比1 较 周林，屈刚，罗栓定 (中国水利水电第二工程局有限公司，陕西西安 71(016) 摘要:高强钢巳广泛应用于水电站引水压力钢管且使用的钢材级别也越来越高。 通过对日产和国产 两个不同牌号 800 MPa 级高强钢的冷裂纹敏感倾向分析、斜 Y 焊接性试验以及焊接工程的施工实践， 对两种材料进行比较，认为日产钢板的焊接性略优于国产铜板，但价格昂贵。 国产WSD690E 高强钢虽对某 些焊接条件要求更加严格一些，但焊接性仍较好，接头满足各项技术指标要求，材料的性价比高。 关键词: 800 MPa 级高强钢;焊接性试验;比较 中图分类号: 1ω57.1 文献标志码:A 文章编号:1001 -2303(:却13)10-0067翻 DOI: 10.75 12/j.issn. l∞1-2303.2013.10.16 Comparison of weldability test 00 two brands 800 MPa high tensUe steel ZHOU Lin ,QU Gan g ,LUO Shu an-ding (Sinohydro Bureau No.3 Co. ,Ltd. ,Xian 71∞16， China)) Abs国ct: High tensile steel wi由 higher and higher cl脑 had been widely adopted in the penstωk ∞nstruction of hydropower station.ηle paper compares 由e weldability test wi由 regard to analyze the cold crack sensitivity ,slit type cracking test and cons阳ction practice of welding engineering on 8∞MPa high tensile steel of two different brands produced in Japan and China. From the view of comparison two kinds of steel plates. the welding manufacturability of steel plate manufactured by Japan China is sligbùy better than domestic brand but wi出 higher cost. Domestic WSD690E high tensile steel construction r叫uires higher welding conditions in some 归ints. However ,its good wel也b出tyωn realize the high performancelcost ratio with the satisfactory of various technical p缸IUlleters r叫uirements of welded joint . Key wordø:8∞MPa high tensile steel; weldability test; compari.son 工。由于受高强度钢焊接难度大、工艺复杂、易出现 。前言