定义端口寄存器.docVIP

/* 定义端口寄存器 */ #define rGPECON (*(volatile unsigned *)0 //Port E control #define rGPEDAT (*(volatile unsigned *)0 //Port E data #define rGPEUP (*(volatile unsigned *)0 //Pull-up control E #define rGPHCON (*(volatile unsigned *)0 //Port H control #define rGPHDAT (*(volatile unsigned *)0 //Port H data #define rGPHUP (*(volatile unsigned *)0 //Pull-up control H /* 主程序 */ extern void delay(int times); void xmain(void) { rGPECON = ~(322); rGPECON |= (122); //GPE11设置为output rGPECON = ~(324); rGPECON |= (124); //GPE12设置为output rGPHCON = ~(38); rGPHCON |= (18); //GPH4设置为output rGPHCON = ~(312); rGPHCON |= (112); //GPH6设置为output while(1) { rGPEDAT = ~(111);//GPE11 output 0 rGPEDAT |= (112);//GPE12 output 1 rGPHDAT |= (14);//GPH4 output 1 rGPHDAT |= (16);//GPH6 output 1 delay(2000000);//delay rGPEDAT |= (111);//GPE11 output 1 rGPEDAT = ~(112);//GPE12 output 0 rGPHDAT |= (14);//GPH4 output 1 rGPHDAT |= (16);//GPH6 output 1 delay;//delay rGPEDAT |= (111);//GPE11 output 1 rGPEDAT |= (112);//GPE12 output 1 rGPHDAT = ~(14);//GPH4 output 0 rGPHDAT |= (16);//GPH6 output 1 delay;//delay rGPEDAT |= ~(111);//GPE11 output 1 rGPEDAT |= (112);//GPE12 output 1 rGPHDAT |= (14);//GPH4 output 1 rGPHDAT = ~(16);//GPH6 output 0 delay;//delay rGPEDAT |= ~(111);//GPE11 output 1 rGPEDAT |= (112);//GPE12 output 1 rGPHDAT |= (14);//GPH4 output 1 rGPHDAT |= ~(16);//GPH6 output 0 delay(2000000);//delay } } ;汇编指令延时程序 EXPORT delay AREA DELAY,CODE,READONLY ;该伪指令定义了一个代码段，段名为Init，属性只读 ;下面是延迟子程序 delay sub r0,r0,#1 ;r0=r0-1 cmp r0,#0x0 ;将r0的值与0相比较 bne delay ;比较的结果不为0（r0不为0