怎样检测硬盘内部短路.docVIP

Department: CSO 附件一: PCBA - EOS TEST MEASUREMENT NO: MF001-A STANDARD OPERATING REV: A PROCEDURE PAGE: 1 OF 4 DOCUMENT GENERATED FROM ECR REVISION ORIGINATOR DESCRIPTION OF CHANGES Rev A KeanPeng Lim New released CURRENT REVISION SEAGATE TECHNOLOGY CONFIDENTIAL (All printed copies are UNCONTROLLED) Department: CSO PCBA - EOS TEST MEASUREMENT NO: MF001-A STANDARD OPERATING REV: A PROCEDURE PAGE: 1 OF 4 SCOPE: To provide the impedance measurement test step for customer. 范围：为客户提供阻抗测试步骤 Tools 工具: 1. Digital multimeter - One set 数字万用表－1 台 2. SATA DC power cable - One set SATA 直流电源线－ 1台 Impedance reading Spec: 阻抗读数标准： PCBA short circuit for +5V = Equal or less than 2000 Ohm PCBA+5V 短路＝小于等于 2KΩ short circuit for +12V = Equal or less than 2000 Ohm PCBA+12V 短路＝小于等于 2KΩ Impedance test (+5V and +12V) Mmeasurement Process For Pata Drive PATA 硬盘(+5V and +12V)阻抗测试 1. Adjust the multimeter selection switch to Ohm range 将万用表调为欧姆档 2. Measure the 5V point impedance test by attach the multimeter probe pin (positive)to PCBA +5V pin point and negative probe to ground/screw hole(Refer to Figure A) 5V 阻抗测试，用万用表的正极探针（红色）接触 PCBA 板 5V 针脚，负极接地或螺丝孔，如图 Figure A 所示 3. Read the impedance reading at multimter, the ohm meter reading must be greater or equal to 2000 Ohm. Ohm reading equal or less than 2000 Ohm are categorized as short circuit. 读取万用表数值，阻值读数一定要大于等于 2KΩ。读数小于 2KΩ 判定为短路 Department: CSO PCBA - EOS TEST MEASUREMENT