不锈钢栏板扶手施工技术方案.doc

不锈钢栏板扶手施工技术方案 不锈钢栏板扶手施工技术方案提要：不锈钢管在安装时对焊接表面用不锈钢丝刷进行刷洗，避免焊接时对碳的吸收或混入杂质，影响焊接效果。不锈钢的焊接选用手工电弧焊 源自房地产资料下载 不锈钢栏板扶手施工技术方案 不锈钢扶手在制作前根据施工图定出各立杆的准确位置，采用Φ6膨胀螺丝与立杆焊接。施工基层要清理干净。 根据施工图和现场放样图下料，扶手高1000mm，楼梯档板采用12mm厚钢化玻璃，玻璃栏河宽1500mm（根据实际尺寸调整）。 不锈钢管在安装时对焊接表面用不锈钢丝刷进行刷洗，避免焊接时对碳的吸收或混入杂质，影响焊接效果。不锈钢的焊接选用手工电弧焊，焊接时注意调整焊缝间隙，间隙的大小应符合焊接要求（0~）并保持均匀一致，焊缝要饱满。 打磨抛光：焊接完后，先用砂轮机对焊缝进行预处理磨光，然后换用抛光轮进行抛光处理，经过多次抛光，直到焊接缝隙的痕迹不明显。 楼梯栏河采用卡槽式安装，卡槽与立杆的连接有焊接和锚固两种，且两卡槽中距不宜大于450mm，卡槽下端头为封闭式，卡槽与玻璃连接处嵌入橡胶条。 楼梯扶手的质量检验标准为栏杆垂直偏差不大于2mm、栏杆间距偏差不大于3mm、扶手纵向弯曲偏差不大于4mm。 源自房地产资料下载 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image quality. The formation of excellent moral education curriculum system and management system, the construction of school. The society, family moral education network, to achieve full member e