乳胶漆墙面施工技术方案.docVIP

乳胶漆墙面施工技术方案 乳胶漆墙面施工技术方案提要：表面平整度控制在2mm以内，并不得有抹纹。表面的缝隙、细小孔洞、麻面等缺陷处用腻子进行填补，分层填平 乳胶漆墙面施工技术方案 本工程内墙多数采用乳胶漆墙面。 ①乳胶漆内墙面施工工艺流程控制程序如下图所示： ②墙面抹灰表面乳胶漆施涂流程图如下： 墙面清扫→填补缝隙→局部刮腻子→磨平→第一遍满刮腻子→磨平第二遍满刮腻子→磨平→干性油打底→第一遍乳胶漆→复补腻子→磨平（光）→ 第二遍乳胶漆→磨平（光）→第三遍乳胶漆。 ③内墙乳胶漆施工技术要点： a.内墙乳胶漆墙面施工应在墙面含水率10%及其以下才能进行。 b.将基体表面的岩土、松散颗粒，附着的砂浆、钉子、铁丝等清除干净，如有油污必须清洗干净。 c.表面平整度控制在2mm以内，并不得有抹纹。表面的缝隙、细小孔洞、麻面等缺陷处用腻子进行填补，分层填平，干后再用砂纸打磨平整。 d.第一遍满刮腻子时，用胶皮刮板满刮，达到平整、均匀、光滑，不得接槎，待腻子干燥后用砂纸磨平磨光，不得有划痕。磨光后将粉末清扫干净，随即进行第二遍满刮腻子，第二遍刮腻子时与第一遍做法一样。 e.第一遍乳胶漆宜稍稀，充分搅拌均匀，并宜过滤，配料应满足整个房间的需用。由于乳胶漆表干较快，需要注意配合人员并加快操作，要求刷到、刷均，而且不显接槎，待这遍涂料干后，对有裂纹、不平或漏刷处，要复补腻子，腻子干后用砂纸磨平磨光，立刻清扫干净。第二遍乳胶漆必须充分搅拌均匀，才能进行涂抹，涂抹方法同第一遍。 f.成品保护。涂刷完毕后，要将门窗、地面、窗台及设备等沾有乳胶漆腻子的地方擦洗干净，然后将房间暂时封闭，注意保护。 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological quality and image q