工程钢筋工安全技术交底（七）.docVIP

工程钢筋工安全技术交底（七） 工程钢筋工安全技术交底（七）提要：多人合运钢筋，起，落，转，停动作要一致，人工上下传送不得在同一垂直线上.钢筋堆放要分散，稳当，防止倾倒和塌落 工程钢筋工安全技术交底（七） 一、钢筋的制作，绑扎 1、钢材，半成品等应按规格，品种分别堆放整齐，制作场地要平整，工作台要稳固，照明灯具必须加网罩. 2、拉直钢筋，卡头要卡牢，地锚要结实牢固，拉筋沿线2米区域内禁止行人，人工绞磨拉直，不准用胸，肚接触推杠，并缓慢松解，不得一次松开. 3、展开盘圆钢筋要一头卡牢，防止回弹，切断时要先用脚踩紧. 4、人工断料，工具必须牢固.掌克子和打锤要站成斜角，注意扔锤区域内的人和物体.切断小于30厘米的短钢筋，应用钳子夹车，严禁用手把扶，并在外侧设置防护箱笼罩. 5、多人合运钢筋，起，落，转，停动作要一致，人工上下传送不得在同一垂直线上.钢筋堆放要分散，稳当，防止倾倒和塌落. 6、在高空，深坑绑扎钢筋和安装骨架，须搭设脚手架和马道，严禁攀沿钢筋笼. 7、起吊钢筋骨架，下方禁止站人，必须待骨架降落到离地1米以内时方可靠近，就位支撑好方可摘钩. 二、钢筋机械 1、切断机运转正常，方准断料.断料时，手与刀口距离不得少于15公分，活动刀片前进时禁止送料. 2、切断钢筋禁止超过机械的负载能力，切断低合金钢等特种钢筋，应用高硬度刀片. 3、切长钢筋应有专人扶助，操作时动作要一致，不得任意拖拉. 4、切短钢筋须用套管或钳子夹料，不得用手直接送料. 5、切断机旁应设放料台，机械运转中严禁用手直接清除刀口附近的短头和杂物.在钢筋摆动范围和刀口附近，非操作人员不得停留. 6、操作除锈机时，应戴口罩和手套.带钩的钢筋严禁上机除锈.除锈应在基本调直后进行.操作时要放平握紧，站在钢丝刷侧面. 7、机械上下不准堆放物件，以防机械震动落入机体. Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good