木龙骨吊顶工程施工方法与技术措施.doc

木龙骨吊顶工程施工方法与技术措施 木龙骨吊顶工程施工方法与技术措施提要：次龙骨安装，采用50mm*50mm或40mm*60mm方木。次龙骨安装前需将确定的面层刨平刨光，以保证吊顶的面层平顺光滑 自建筑施工资料 木龙骨吊顶工程施工方法与技术措施 1、施工工艺 施工准备--放线--吊筋--木龙骨安装--面板安装 2、施工方法与技术措施 （1）根据设计标高、弹水平线，即在吊顶四周墙面弹出墨线，偏差应控制在±5mm以内。 （2）主龙骨安装，采用80mm*80mm或100mm*100mm的方木，将吊顶主龙骨与钉入的木楔固定，或用8mm-10mm的钢筋吊件与膨胀螺栓固定。 （3）次龙骨安装，采用50mm*50mm或40mm*60mm方木。次龙骨安装前需将确定的面层刨平刨光，以保证吊顶的面层平顺光滑。 （4）次龙骨与主龙骨垂直安装，沿墙龙骨用木楔固定墙面，安装后底面的刨光面应位于同一标高。 （5）钉中间部分的次龙骨时，要按规定起拱，一般7-10m跨度的房间按3‰起拱，10-15m跨度的房间按5‰起拱，起拱高度偏差控制在±10mm以内。 （6）根据设计要求进行分档划线，档的大小应与面层板尺寸相适应。次龙骨间距一般控制在400mm-500mm。 （7）钉固时要先钉次龙骨，后钉主龙骨，主龙骨的间距控制在300-400mm，并用铁钉与次龙骨钉牢，选用的钉子长度80-90mm,以保证能斜向穿次龙骨与主龙骨牢固连接。 （8）罩面板铺钉A、安装时在龙骨上弹好线，由中间顺线向两边钉。B、采用双层板时，板缝错开。木压条、装饰条应平直、宽窄一致、转角处须割角拼接流畅、美观。c、罩面板力求颜色一致、木纹协调、图案完整。 自建筑施工资料 Measures for the routine management of moral education in Middle SchoolsMethod of conventional management of moral education in middle schoolFirst, the guiding ideology:School moral education is an organic whole of the whole education work, always adhere to the school adhere to the moral education, education for this product, and actively promote the quality education, the school building efficient curriculum system of moral education, moral education, improve the sense of attraction and appeal, enhance the moral education work for through and timeliness. Teach everyone, service education and management education, and school moral education work must be with family education and community education closely together, to form a concerted pattern, and strive to create a good atmosphere for education, and to promote the all-round development of students, to establish a scientific moral education full of vigor the For long-term mechanism.Two, the goal of moral education:To guide the students to form the correct world outlook, outlook on life, values, to cultivate students unity and mutual assistance, honest and trustworthy, law-abiding, good quality, hard work, set a good XX students ideological quality, psychological qu