LINK10单位描述(国外英文资料).docVIP

LINK10单元描述(国外英文资料) LINK10 unit description Name: LINK10-3d only being pulled or only under pressure bar unit Effective products: MP ME ST PR PP ED LINK10 unit: The unique bilinear stiffness matrix feature of LINK10 unit makes it an axis only supported by a pull or a compression bar unit. Using the only pull option, the stiffness disappears when the unit is pressed to simulate the slack of the cable and the slack of the chain. This feature is very useful for the static problem of the steel cables used to simulate the entire cable in one unit. It can also be used for dynamical analysis (with inertial or damped effects) when it needs the performance of the relaxation unit, not the motion of the relaxation unit. If the units movement (no slack unit) is studied for the purpose of analysis, you should use a non-relaxed unit similar to LINK10, such as LINK8 or PIPE59. For the structure of the final convergence results for taut state, if possible laxity in iterative process, then the static convergence problem cannot use LINK10 unit. Other units should be adopted or slow power techniques. LINK10 unit on each node has three degrees of freedom: the node coordinates X, Y, Z direction of the translation, whether it is only in tension (cable) option, or only compression (rip) option, this unit does not include bending rigidity. This unit has the function of stress rigidization and deformation. For details, refer to ANSYS, Inc. The input data The geometry of the cell, node location and coordinate system is shown in figure 1, the unit through the two nodes, cross section, initial strain or clearance and all the people of the same material properties to define. The X-axis of the unit is the length of the unit length along the node I to the node J. Initial strain (ISTRN) given by Δ/L, here Δ is a unit of length L (defined by the location of the nodes I and J) and the difference in value between zero strain length Lo. For the cable option, the negative strain value indicates that it