unit14(国外英文资料).docVIP

unit14(国外英文资料) And all the variations are given by the other tolerance. A mean dimension is used which extends to the midpoint of the tolerance zone with equal plus and minus variations on each way from this dimension. Tolerance can be either unidirectional or bi-directional. A one-way note has a tolerance of zero, and all changes are given by another tolerance. The bidirectional annotation adopts an average size, and it extends the midpoint of the tolerance band from that dimension to the positive and negative range. The development of production The processes for large - volume manufacture at low cost has had largely dependent upon interchangeability of component parts. Thus, The designer must determine both The proper tolerances for individual parts, and The correct amount of clearance or interference to permit The assembly with The mating parts. The development of large-scale, low-cost manufacturing processes depends largely on the interchangeability of the components. Therefore, the designer must determine the proper tolerances of the individual parts and the correct clearance or oversupply of the parts. The manner of placing tolerances on drawings depends somewhat on The kind of product or type of manufacturing process. If The how on a dimension is not specifically stated, The drawing should contain a blanket note which gives The value of The how The for to dimensions. The method of labeling tolerances on a drawing is largely dependent on the nature of the product or the type of manufacturing process. If the size tolerance is not specified, the drawing should contain a general applicable comment that gives the tolerance value of these dimensions. Clear that some companies do not use blanket notes on the supposition that if each dimension is considered individually, wider tolerances than those called for in the note could probably be specified. In any event it is very important that a drawing be free from ambiguities and be subject only to a single interpretat