不同成型方法对透水混凝土性能的影响研究.pdfVIP

学兔兔 2011年第 11期(总第 265期 ) 混 凝 土 实 用 技 术 Number 1 1 in 201 1(Total No 265) Concrete PRACTICAL TECHNOLOGY doi：10．39690．issn．1002—3550．201 1．1 1．041 不同成型方法对透水混凝土性能的影响研究 徐仁崇’。桂苗苗’。龚明子’，刘君秀 ，陈清己， (1．厦门市建筑科学研究院集团股份有限公司，福建 厦门361004；2．厦门天润锦龙建材有限公司，福建 厦门361009) 摘 要：研究了4种成型方法对透水混凝土抗压强度及透水系数的影响。结果表明：随着振动时间和成型压力的增加，透水混凝土的抗 压强度先增大后减小，而透水系数则逐渐降低；插捣成型法可以使透水混凝土获得较高的透水系数但抗压强度较低；振压成型法可以使透 水混凝土获得较优的抗压强度及透水性能；压力成型法和振压成型法可以作为透水混凝土实验室配合比成型方法；透水混凝土路面的施 工方法及施工机械的参数选择应根据试验确定。 关键词：透水混凝土；成型方法；成型压力 中图分类号：TU528．063 文献标志码：A 文章编号： 1002—3550(2011)11—0129—03 Impact of different molding methods on pervious concrete performance XURen—chong ，GU!Miao-miao ，GONGMing-zi ，LKlJun-xiu ，CHENQing-ji (1．XiamenAcademy ofBuildingResearchGroupCo．，Ltd．，Xiamen 361004，China； 2．XiamenTianrtm JinlongBuildingmaterialCo．，Ltd．，Xiamen 361009，China) Abstract： The impact of four molding methods of pervious concrete on its water permeability coefficient and compressive strength was dis— cussed in this paper．Results showed that with the vibrating time prolonged and the compaction pressure augmented，pervious concrete’s water per- meability coefficient fell down gradually while its compressive strength increased initially and then decreased．Hand compaction method presented hi elwater permeability coefficient but lower compressive strength，whereas vibrating compressing method outstood in both the two aspects． Compressing method and vibrating method cai1 serve as laboratory molding methods ofpervious concrete mix proportion．Parameters ofconstmc· tion techniques an