修光圈(国外英文资料).doc

修光圈 Mending (reproduced) 2012-05-1516:57:13 | : the default category | : | is large and small. Test of aperture stability test Customer for lenses andreas requirement is more and more high, how to make the aperture in the process of machining stable state, and shall not affect the work efficiency, does not increase the cost and ensure the quality. Now is the hot topic of discussion. Therefore, it is necessary to find the basic conditions for the stability of the aperture in the part of the representative (representative of the precision of face precision and local error). One, the aperture is unstable reference 1, processing conditions: 1) the size of the powder particle size, the size of the concentration ratio, the effect of the aperture; Grinding powder particle size and concentration is too large, the greater the radius of curvature change of grinding plate, (convex dish curvature radius larger; concave curvature radius of plating) as compared with water, the aperture will change towards the direction of the high; Easy to cause side drape. 2) the speed of the revolution affects the area of the aperture of the aperture, and the edge of the plate is not the same as the linear velocity of the center. The more the lens is placed on the plate, the more the lens aperture changes to the negative aperture. This makes sense when the lens center is low and middle height. 3) the size of the pressure on the center of thin lenses with D/T 10 has a direct effect, (especially) when use string rod processing pressure opposite form is mainly the influence of the lens the size of the whole surface is uneven. 4) processing time also has a change in the shape of the surface of the surface, because the grinding of the cosine grinding, the radius of the curvature of the plate curvature is fixed by the time of the finished product. (because of the constant need to keep the radius of the curvature of the plate, the center of the mill is almost certain.) 5) adjust the size: the pendul