全光明化学镀镍(国外英文资料).docVIP

全光亮化学镀镍 Foshan renchang chemical co., LTD NICHEM 2010 Full light chemical nickel plated (medium phosphorus) 1. Craft characteristics: ? Long cycle life, up to 8-10 cycles (Metal Turn Over), [meaning cycle per liter plating solution will all nickel plating out again when adding to the open cylinder of nickel content is called a loop, a cycle can be deposited coating at least 900 dm2, mu m]; ? The maximum speed can reach 20 to 22 mu m/h; ? Strong plating ability, strong plating ability, fully achieve copy effect; ? High hardness and corrosion resistance; ? Low porosity, 10 mu m without porosity; ? Good wear resistance, better than electroplating chromium; ? The weldability is good and can be wetted by the solder. ? Electromagnetic shielding performance is good for electronic components and computer hard drives. ? The coating is amorphous, non-magnetic Ni -p alloy Coating characteristics: Phosphorus content: 6-9% (wt); The end of the day is the last day of the year. Resistivity: 60-75 mu Ω · cm; Density: 7.6-7.9 g/cm3; The end of the day is a great time. Melting point: 860-880 ℃; Hardness: Hv 500-550 (45-48rch); Resultant force: 400MPa is much higher than electroplating; Heat treatment: Hv1000; ??????????????? Inner stress: lower internal stress in steel than 7MPa The composition and operating conditions of the liquid coating: Raw materials and operating unit The scope of NICHEM 2010 a % (v/v) 50 NICHEM 2010 b % (v/v) 150 pH 4.6 to 4.8 The temperature ℃ 85-90 (87). Loading capacity Dm2 / L 0.5-2.5 (1.5) time Depending on the thickness Depending on the thickness The solution: ? When the cylinder is open, add a half of the water to the tank. ? Add 5% of A and 15% B, and mix well and filter. ? Add the pure water to the required approximate volume. ? Heated to 88 ℃. ? Adjust pH to 4.6-4.8 with ammonia or sulphate ? The filling water to the calibration line can be applied by process. 5. Equipment needs ? Project requirement ? Slot PP, PVC, or high density PE. ? Hang a PP,