安装计算(国外英文资料).docVIP

安装计算 When you get the drawing, check the drawing. Symbol awareness: all unmarked figures are in the case of m, except for the highest units, and the other ones are mm. (schedule 1) all the horizontal tubes that come in from the outside are called dry tubes, and from the dry pipe are called the riser, which is called a branch from the riser. Remember to verify that the ratio is correct (1) electrical engineering (including the strong electric part, the weak part and the ground part of the lightning protection) One, strong electrical parts: 1, familiar with drawings: (1) look at the design specifications, the design of engineering materials and instructions of the lightning protection down all that then instructions are coated with legend, all the illustrations need to count the number of distribution box (different sizes, lamps and lanterns, sockets, switches, etc.) are respectively the statistics number; When you look at the system diagram, you should understand the direction of the pipe. The upper and lower directions of the system graph are generally indicated by a point or circle in the plane graph. The left and right sides of the system chart are left and right on the floor plan; The slope of the diagonal line in the system graph is 45 degrees, indicating the pipeline that goes around the plane. The height of the vertical tube on the system diagram, the horizontal segment length of the dry tube and the branch of the branch can be measured. 2, quantity calculation process: first, from the outside - - - the total distribution box - - - unit distribution box - - - indoor distribution box - - - each loop (lighting, socket, etc.). Step 3: calculate the line after the tube (slot), and the pipe (slot) is not in the box, line (cable) into the box. Relevant regulations: when the outdoor wiring drawings are not marked on the outside, it is reserved for 1.5m (outdoor and outer wall). The length of the cable is 2m and the length of the wire into the box is half the perimete