基于STM32的DS18b20驱动程序.doc

//=========================DS18b20.h=========================// /*----------------------------------------------- ?????????????? DS18b20驱动程序 ------------------------------------------------*/ #ifndef __DS18B20_H#define __DS18B20_H typedef enum{FAILED = 0 ,PASSED = !FAILED} TestStatus ; #define DQ_GPIO? GPIOD#define DQ_GPIO_Pin GPIO_Pin_5 //REGISTER COMMANDS#define REGISTER_9_BITS? 0x1F#define REGISTER_10_BITS 0x3F#define REGISTER_11_BITS 0x5F#define REGISTER_12_BIT2 0x7F //ROM COMMANDS#define ROM_Search_Cmd?? 0xF0#define ROM_Read_Cmd???? 0x33#define ROM_Match_Cmd??? 0x55#define ROM_Skip_Cmd???? 0xCC#define ROM_AlarmSearch_Cmd 0xEC //DS18b20 FUNCTION COMMANDS#define Convert_T????????? 0x44#define Write_Scratchpad? 0x4E#define Read_Scratchpad?? 0xBE#define Copy_Scratchpad?? 0x48#define Recall_EEPROM???? 0x88#define Read_PowerSupply? 0x84 #define DQ_Write_1()???? GPIO_SetBits(DQ_GPIO ,DQ_GPIO_Pin)? //写1#define DQ_Write_0()???? GPIO_ResetBits(DQ_GPIO ,DQ_GPIO_Pin)//写0#define DQ_ReadBit()???? GPIO_ReadInputDataBit(DQ_GPIO ,DQ_GPIO_Pin) //读DQ上的值 extern void GPIO_DQ_Out_Mode(void) ; //DQ输出模式extern void GPIO_DQ_Input_Mode(void) ;? //DQ输入模式 extern void Tx_ResetPulse(void) ;??? //发送复位脉冲extern void Rx_PresencePulse(void) ; //接受应答信号 extern void Write_OneByte_ToDS18b20(unsigned char data) ; //写一个字节到18b20extern unsigned char Read_OneByte_FromDS18b20(void) ; //从18b20读一个字节extern void Read_Temperature(unsigned char *sign ,unsigned char *interger ,????????????????????? unsigned int *decimal) ; //读温度//写配置参数TH，TL和初始化配置寄存器extern void Write_EEPROM(unsigned char Th,unsigned char Tl,unsigned char Register_Con ); void DS18B20_Init(void) ; //初始化 #endif /*DS18B20*/ //=================================================================// //=========================DS18b20.c================================// #include stm32f10x_lib.h#include DS18b20.h#include SysTick_Delay.h /******************************************函数名称：GPIO_DQ_Out_Mode功??? 能：设置DQ引脚为开漏输出模式参??? 数：无返