口腔助理实际技能测验(第二考站)(国外英文资料).docVIP

口腔助理实践技能考试(第二考站)(国外英文资料) One. Basic oral technology: ten minutes, 25 minutes The opening of the medullary: (leaving the front of the body or grinding the teeth) Operating procedure: 7 1) equipment selection: high-speed turbo needle, ball drill. 2) hold the method: pen type. 3) pivot points: (choose the appropriate fulcrum, be sure to be stable. Do not support the soft tissue. Position and cavity: 5 points Open position: Front teeth: the entrance is in the center of the joint, and the oval shape is slightly longer. Upper jaw: the jaw of the jaw is the tip of the cheek, forming a slightly longer oval shape. Note that the neck is more delicate. Upper jaw molar: from the tip of the tongue of the tongue, and then push it to the side of the buccal side of the buccal, the shape of the buccal cavity is approximately triangular. Lower jaw: tip the cheek to the cheek The tip of the tongue is slightly larger than the center. 1) point mill, gradually expand, deepen the pulp 2) the pulp of the pulp is opened, and the top of the marrow is revealed 3) repair the lateral wall of the pulp chamber and check for the root canal. Pulp chamber top to net: ball drill wear after pulp is determined, can expand to other pulp horn, several medullary Angle connected. After pulp removed, a pith Angle to another pith Angle extension in the lateral force, can prevent the bottom wear. The root canal is exposed: the root canal is exposed, and the root canal is open to the root canal Bottom integrity: note that the drill is not too deep to damage the bottom of the pulp. Gingiva: 10 minutes Patient: 1) adjust the chair position: lower jaw: the jaw line is parallel to the ground Upper jaw: the jaw plane is 45 degrees from the ground 2) doctor: in front of the patients right or rear Instrument selection: 1) instrument selection: large stone. Hoe: small block of gum, soft scale pigment. 2) grip: improved grip pen type: an instrument valve stem with middle finger abdomen, index finger bend located above