消防救火流程Fire Fighting Procedures.docx

消防救火流程1．一旦发现火情，及时通知EHS 和生产值班经理（由生产提供值班表和值班经理电话，由EHS提供EHS电话）。2．由生产值班经理组织救火人员赶赴现场，现场生产人员应积极参加救援行动。3．根据火情地点，识别就近能使用的消防栓和消防箱。消防栓→→→ 到消防应急小屋取水袋，水枪和扳手消防箱→→→ 直接使用4．抛开水袋，保持水袋平整，确认平整后，才能打开出水开关。（由消防栓/箱处的人确认）。5．两人配合灭火，一人在消防栓（箱）处，一人手持水枪。打开出水开关前，两人分别确认水袋与消防栓/箱、水袋与水枪已连接稳固。6.使用消防扳手打开出水开关时，应缓缓开启，避免另一端手持水枪的人因为突然水压增大而准备不足，发生伤害。7．采用吊射的方式灭火，不要直接将水对着火源冲。8．若需要（木炭起火时），可用装载机配合捣开起火炭垛。9． 如果火势过大，由EHS部决定是否通知消防救援。10．灭火后，排空水袋中遗留水，并晾晒干水袋。11．灭火后，及时将水枪，扳手收回原处，待水袋晒干后也一并收回原处（由领取人完成）。Fire Fighting ProceduresOnce fire is noticed, immediately inform EHS and duty manager(Production Department should provide the schedule of which manager is on duty and their telephone numbers, EHS should provide their telephone numbers)Duty manager is in charge of organizingfire fighters to go to the scene. All production workers present should actively take part in the fire fighting action.Depending on the location of fire, find out the nearest function Fire Hydrant.Fire Hydrant→→→go to fire equipment cabin to bring fire hose, wrench and branch.Fire Hydrant cabinet→→→use directly.Throw over and roll the fire hose to keep it flat, after making sure it’s flat, worker can turn on Fire Hydrant.(People near Fire Hydrant is in charge of making sure the flat of fire hose)Two men need to co-work to put out a fire, one man stand near Fire Hydrant and the other hold Fire branch against The fire. Before turn on Fire Hydrant, the two should confirm the connection of all fire fighting parts is tight.When using fire wrench to turn on Fire Hydrant, the movement must be slight to avoid potential danger due to the man may be not well-prepared to water coming out so rapidly.Point the water to sky to let it pour over the fire, do not shot the water directly to the fire.If needed(charcoal is on fire), use the loader to help separate.If the fire is gone out of control ,it’s EHS to determine calling Fire Fighting Department for help or not.After putting out fire, the water in Fire hose need to be discharged, then air Fire hose until it’s dry.