JB—4C周详粗拙度台阶测试仪(国外英文资料).docVIP

JB—4C精密粗糙度台阶测试仪(国外英文资料) The menu shown in the first line of the window is defined as follows: File: showing the initial state; The vertical coordinates display a small red line representing the sensor The height of the needle. Open: open an existing document and provide access. Save: save or replace an old file with a new file name. Curve: a contour line showing the sample. Sphere: roughness report showing an arc or sphere measurement. Flat: roughness report showing flat surface measurements. Sampling: sample once. Left shift: the sensor moves to the left. Right move: the sensor moves to the right. Stop: stop left or right. Parameter: set sample length, section number, sensor contact type And measuring surface. Print: print the test results. Help: display program information, copyright, and copyright. Step: measure the steps. Pt: measure Pt display. Turn clockwise or anticlockwise: fine-tune the sampling graph to make it parallel to the X-axis. 2.2.2 sensor location adjustment: see figure 2.3 The adjustment stage is shown in view of 2.4. 1-granite slab 2-table 3-v block 4-glass template 5 - sensors 6 - high and low for 7 - Angle adjustment 8 - silk bar 9-stand 10-drive box 11-switch 12-control box Figure 2.3 1 - oscillating knob 2 - X axis moving thread 3 - Y axis moving silk rod 4, turn the knob Figure 2.4 Refer to figure 2.3 and 2.4; Press the control box panel on the left side of the down arrow key, can be connected to the motor drive the column (9) in the middle of the screw rotation (8), so that the driver box (10) move down; When the sensors contact with the needle and the workpiece is automatically stopped, watch the red dot on the vertical coordinate of the display, which indicates the position of the sensors pin on the top and bottom axis. Such as test flat, rotating on red dot height adjustment (6) to near zero, and then press the left and right arrow keys or click with the mouse control box panel menu left or moves to the right key, slide on the effectiv