《塑料模具设计》2011期末考卷B谜底(国外英文资料).docVIP

《塑料模具设计》2011期末考卷B答案(国外英文资料) The final paper Class: name, student id: The first semester of the 2011-12 school year Plastic mould design final exam paper B Item no. a The second three four five six seven Total score Review one Should the score 15 10 10 15 20 20 10 100 Real score Where some people 1, fill in the blanks (1 point, 15 points) 1, plastic pieces of uniform wall thickness requirements, otherwise it will generate additional stress caused by different cooling and solidifying speed, so that the internal stress is generated in plastic parts in plastic parts warp, produce the defects such as shrinkage cavity and crack. 2, the injection molding process need to control the temperature of the material barrel temperature, nozzle temperature and mold temperature, the first two main influence plastic plasticizing temperature and flow; Then a temperature mainly affects the flow and cooling of plastics. Injection molding is commonly used in the forming of thermoplastic plastic. The compression mode is mainly used for the forming of thermosetting plastics. The extrusion process parameters are mainly temperature, pressure, extrusion speed and traction speed. When the non-balance arrangement is used, the size of the gate is adjusted to achieve the balance of the pouring system. The BGV value is often used for evaluation or design. In order to facilitate the removal of the plastic parts, in the ordinary case, the plastic parts are left on the moving die. There are many kinds of compression modes, which are classified by the structure of the loading chamber And semi overflows. Second, the choice (2 points, 10 points) The effect of the squeezing ring is to limit (B) the descending position, ensuring the thinnest level of the flying side. A) adding room B In the following three statements, the correct is (A). In the ejection mechanism, the top rod should be set in the area near the drag force. The plastic parts can only be from the top of the moving mold. In the case of C., t