交换性 第五章、第六章习题谜底(国外英文资料).docVIP

互换性 第五章、第六章习题答案(国外英文资料) Chapter 5. Problem sets 5.1 Shape orientation Meet minimum requirements 3. More than Vertical plane degree 5. Parts length L 5, 9 7. Run-out tolerance Factors of run-out tolerance is associated with the actual datum axis rotation around a week or a few weeks when the allowed maximum pumping quantity, is a specific method of measurement tolerance of the definition of project, comprehensive to limit measured elements of shape and position error. Simulate fit 9. Single inclusion principle requirement is dimensional tolerance and shape tolerance to each other about a related requirements. It applies only to a single dimension element (cylinder, two parallel plane reverse) of the relationship between the size tolerance and form tolerance. Using the size of the tolerance requirement elements, the actual contour shall comply with the largest entity boundary, namely the in vitro effect size does not exceed the maximum physical dimensions, and local actual size does not exceed the minimum physical dimensions. 10. Space straight line 5.2 1 minus 5: times the square root of the square root of 6 minus 8 5.3 1 minus 5: C, D, B, C, C, 6-8: B A D 5.4 What are the geometric errors that can be measured by the measurement of the pulse and the measurement of the axis? Answer: the radial beat can measure the circle degree error, the concentricity error, the cylinder error and the coaxial error. The axial jump can measure the plane degree error and the verticality error. What is the difference between the maximum entity state and the maximum entity? A: the maximum entity state refers to the state of the actual elements within a given length, which is within the limit of the limit and the maximum state of the entity. Largest entity state of actual effect is refers to the actual elements to ensure that the first in the largest entity state, at the same time also to meet its central elements in shape or position error is equal to the given tolerance values, only to