板式橡胶支座实用标准(国外英文资料).doc

板式橡胶支座适用规范(国外英文资料) Applicable specification for plate-type rubber pedestal. (JT/t4-2004)? Entry requirements: Sign:?? Each rubber seat should be permanently marked; 2. Packing:? Support should be packed according to classification and specification. Packing should be firm and reliable, and the product name, specification and date of manufacture should be indicated outside the packing. The packing shall be enclosed with the certificate of the product. According to the routine inspection item of the batch number three:, the limit compressive strength. The modulus of compressive modulus The rubber bearings are given six pieces per batch, three of which are destructive testing, three can be returned, and the four fluoroplate can be free of the test of the elastic modulus of shear resistance. Special note: 1, according to the practical experience, if the pedestal is armour for (generally the owner to do so), the same specifications as far as possible let a send enough material business, dont send dozens of each batch. Otherwise the tests will be expensive. In normal test, the modulus of compressive elasticity exceeds the design value (unqualified), and when the external commission reports back, it needs to be checked carefully. In addition, the problem was found in guangdong province in 2009, which reported that the compressive modulus of compressive modulus exceeded the range in the report, but the report concluded that it was qualified. There is a place for discussion, and it is important to find and correct it early. The anchor shall sample the inspection information How to sample the line, anchor and clip on the bridge? Author: the free world Engineering class: bridge engineering test category: raw materials - anchor, clip, connector sample specification name: GB/T? 14370-2000 prestressed reinforcement with anchor, clip and connector test specification name: GB/T? 14370-2000 anchor tools, clip and connector acceptance specification: GB/T? 14370-2000 test project of