口腔内科学1014(国外英文资料).docVIP

口腔内科学1014(国外英文资料) The hole filling (1) the bottom of the single layer: the middle depth of the hole, the base of the tooth pulp of the cavity is greater than 1mm, usually only the bottom of the single layer. The most commonly used materials are zinc phosphate cement and zinc carboxylate cement. 1) zinc phosphate cement mixing method: according to the size of the socket hole, take proper amount of powder and liquid respectively on glass or cardboard, with a dry and clean mixing knife powder into two portions, one of the first mixed with liquid, with mixing knife with flat glass blender rapidly rotating way, pay attention to avoid in the cement form bubbles, and then the rest a into several portions, one by one to join, to tune into the consistency. When used for hole filling, it should be slightly thickened to increase the strength and reduce solubility. When the powder is removed, tighten the cap of the bottle immediately to prevent the liquid from losing water. In the mix of sticky powder, it cant be added to the liquid, or it will block its crystallization. Mixing too quickly can produce a lot of heat and accelerate the solidification. In mixing and filling, you should avoid contact with moisture, which will affect the strength of the adhesive powder. 2) poly (carboxylic acid zinc cement mixing: due to the different varieties and use purpose, powder, liquid press l: the weight of the 5 ~ 2:1 ratio respectively under harmonic board or mixed paper, first half of powder, and the liquid mixing, and mixed evenly, and then to add the rest of the powder with a small amount of gradually, until the required consistency. The mixing should be finished in half a minute. Do the bottom with a bit more thickening, and the stickability of the fixer is less. 3) at the bottom: after lie between wet and dry socket hole, according to the size of the socket hole, depth, take a suitable amount of cement in the nest inside the hole, the hole bottom spread out to the point, line Angle of