《修建结构》期末温习测试卷(国外英文资料).docVIP

《建筑结构》期末复习测试卷(国外英文资料) The final test volume of architecture (20 questions in total, 100 points.) The condition of the tensile failure of the reinforced concrete eccentricity is () A. eccentricity is larger and the bar is too heavy The center is larger and less reinforced C. the eccentric is smaller and the bar is too heavy D. eccentricity is smaller and slightly less reinforced Full marks: 5 When designing the torsional component of the reinforced concrete, the torsion and torsion reinforcement is stronger than xi. unrestricted B. 2.0 Full marks: 5 The normal limit state is compared to the capacity limit state (). A. allow for higher probability B. The probability of an appearance is smaller C Full marks: 5 The high carbon steel reinforcement adopts the conditional yield strength, with sigma 0. 2 is the same thing as that. Strain is the stress at 0.02 Strain is the stress at 0.002 The limit is 20% Take the stress of the residual strain at 0.002 Full marks: 5 In the calculation of the normal limit state, the load effect should be taken as the standard value (). A. right B. errors Full marks: 5 When designing the torsional component of the reinforced concrete, the torsion and torsion reinforcement is stronger than xi. unrestricted B. 2.0 Full marks: 5 In order to improve the extreme strain of the compression component of the reinforced concrete axis, should () A. use high strength concrete B. use strong bars C. use spiral straps D. increase section sizes of components Full marks: 5 The concrete design strength of the concrete structure design code of our country is () A. average strength The strength of a certain guarantee C. Times the standard strength of K after the safety factor D. Divided by the standard strength of K Full marks: 5 When the reinforced concrete beams are lined up and lined up, the distance between the two points is less than the Smax. The purpose of this is to guarantee (). The ability of inclined section to resist bending The shear resistance of