一级建筑师收集计划(国外英文资料).docVIP

一级建造师网络计划(国外英文资料) The concept and calculation of total jet lag. Three, six time parameters and the calculation procedure Four, the time parameter is the main calculation formula Application of the principle of labor Claims (contract claims and network planning) 7, common claims time. Engineering change 9, actual construction period The period of reward and punishment Candidates are doing primary constructor double code network chart drawing questions, must grasp the drawing of the eight rules, such as: double code network diagram must be determined correctly express has logical relationship; In the double codename network diagram, there is no link between the nodes and the arrows. In the double codename network diagram, there is no arrow or no arrows. ???? Double code network drawing rules: A double code network diagram must correctly express the identified logical relationship. No loops are allowed in the double code network diagram. The so-called loop circuit is the line that starts from one of the nodes in the network diagram and follows the arrow line back to the original starting line. In a double codename network diagram, there cannot be a two-way arrow or no arrows between nodes. In the double codename network diagram, there is no arrow or no arrow at the end of the arrow. 5, when some nodes of double code network diagram of multiple arrows line or more introverted outgoing line, in order to make the graphics is concise, can use method of bus bar drawing (but should satisfy a job with an arrow line and the corresponding pair of nodes). When drawing a network diagram, the arrow line should not cross. When the crossing is unavoidable, the bridge method or the point method is available. 7, the double code network diagram should be only a start node and a destination node (with the exception of multiobjective network planning), and all the other nodes are should be the intermediate nodes. The double codename network diagram should be organized and reasonable. ??