加气砖施工方法(国外英文资料).doc

加气砖施工方法(国外英文资料) The construction method of the steam-pressed grey brick masonry Masonry mortar. The wall wall should be made of M5 and above mixed mortar masonry. The mortar should be used in mortar and mortar, which can increase the strength of the wall. Stone plaster should be cooked up to 14 days, preventing the phenomenon of blasting due to lack of cooked time. Should not adopt a kind of additives, such as king of lime because of its main ingredients are micro expansive agent, will cause the late mortar strength more and more low, even produce strength of mortar strength become no phenomenon; It is also inappropriate to use the bag of lime powder, which should be more than 3 days if you have to use a bag of lime powder. The brick foundation of above and above 0.000 should be built by M10 and above cement mortar and steam crushed mortar brick, concrete solid brick (strength should be greater than MU15). Grey seam thickness. Vertical and the horizontal mortar joint thickness of the masonry mortar joint width should be controlled in 10 ㎜, allowable deviation plus or minus 2 ㎜, horizontal and vertical laying requirements. Special attention should be paid to the construction of the joint of the masonry and the column. The seam should not be too thick and be tight when the masonry is built. 3, the ashes are full. Masonry mortar joint must be full, according to the masonry construction quality acceptance specification clause 5.2.2: masonry mortar plumpness of horizontal mortar joint, shall be calculated on net area shall not be less than 80%; According to the regulation of steamed plaster brick and the empty brick of the steam press, the slurry is not less than 70% full. To apply masonry mortar to the vertical joint. No blind or transparent seams are allowed. It is very important that the thickness of the mortar and the quality of the mortar, the quality of the wall, the shear strength of the masonry and the prevention of shrinkage crack are very important. At present