投影机的选型(国外英文资料).docVIP

投影机的选型(国外英文资料) The selection of teaching projectors What is the practical need to consider? The higher the resolution of the projector, the more expensive it is. So were going to have to decide what class of projectors were going to buy in terms of the actual projection. For the typical education application and the general software world demo, the selection resolution is 800 x 600 (SVGA) mid-range product to meet the needs. If the quality of the picture is high, the choice is 1024 x 768 (XGA). Also consider the interface design of the projector and other electrical equipment compatibility. ?? ? There are two types of LCD and DLP that are common in the market from the actual installation environment. The imaging device of LCD projector is LCD panel, which is high in brightness, good color and moderate price. But its light source life is short, the resolution is low, the volume is large, the component weight. DLP (digital light processor) projection as the light valve imaging devices in digital micro reflector, the projector image noise, image quality is stable, high resolution, image uniform, sharp colors. Therefore, when the choose and buy must consider to install the projector and the light of the size of the room, if the request is not high to the environment, the display area is larger, used in teaching demonstration or small meeting room, can choose the LCD projector, if want to pursue the display of color and uniformity of sharp, can choose DLP projector. ? 3, is it reasonable to choose brightness? For class area is below 80 square meters, 1000 ANSI lumens products can meet the application, such as the classroom area is larger, should according to the size of the actual environment, the environment light and the size of the picture, and so on and so forth to determine the placement of the projector brightness, do just enough, unnecessary to pursue high brightness. ? The convenience of connecting and operating? Teaching projectors often form an electrochemical