搭接结构(国外英文资料).docVIP

搭接构造(国外英文资料) ? How do you see the structure of the regular reinforcement, the frame, and the negative reinforcement of the reinforcement from the picture on page 03g101-1? ? The problem? 1. Does the erection of the brace and the subside of the position do not appear on the picture on page 54? Answer:? The contact points of Ln / 3 in the 54th page of the 03g101-1 atlas are both the connecting points of the upper and the negative reinforcement of the upper pass, and the connecting points of the vertical and the negative reinforcement. The two are not confused or contradictory. Many people ask such questions because they dont know much about the rules of drawing ( view ) and the structure of steel bars. ???? From the position of the steel bar, the two upper parts of the beam are located in the two vertical angles of the hoop, and if the top view of the beam is drawn, it is on the sides of the beam. And the vertical bar is in the middle of the beam. For example, a beam, which is labeled 2 phi 25 + (2 phi 12), is marked with phi 8 @ 100/200 (4), which is the hoop. In situ there are four phi twenty-five. Is from the vertical view point of view, this beam on both sides of two phi 25 the upper part of the tong long tendons tendons) (currently is also well versed in, and have 2 phi 12 of beam frame made of steel, and in the middle of the 2 phi 25 支座负筋 lap in Ln / 3 place, the lap length is 150 mm. ???? If just example, liang tong long steel bar in the top of the 18 + 2 phi phi 12 (2), from the vertical view, the both side of this beam 2 phi 18 the upper part of the long bar, with left and right sides of the 2 phi 25 支座负筋 lap in Ln / 3 place, the lap length is LlE. At the same time, there are two phi 12 tendons in the beam, and 2 phi 25 in the center, which is connected to the Ln / 3, with a length of 150 mm. ???? So, in the 54 page, this is not the length of the strap, but the length of the length of the upper part. These situation, on the vertical view of beam can see very