板柱结构系统结构设计(国外英文资料).docVIP

板柱结构体系结构设计(国外英文资料) Structural design of slab column structure The structural system of flat slab without beams is the structure system of slab slab. In our country, the structural system of no girder floor is a new technology which has developed relatively quickly in recent years. Compared with the traditional structure system of the dense rib beam, it has a good overall structure and large building space, which can effectively increase the advantages of the stratum. Moreover, the seismic effect of buildings with no girder building system is also significantly less than that of the larger slab structures. Slab-column system structure system was in the aspect of construction, the use of buildings with simple construction mode branch, convenient floor reinforcement assembling, convenient installation, thus greatly improve the construction speed. Therefore, there are obvious economic and social benefits of using a non-girder structure. In this structure, the design calculation is divided into two main parts: the spatial structure analysis of the structure and the analysis calculation of the ungirder itself. Currently, the PKPM series design software has a mature analysis method for both aspects. Lets take a look at the following: I The overall calculation of the structure of the ungirder floor can be carried out through the software of TAT software or SATWE software in PKPM software. Of course, the two software models are not the same in three-dimensional computing: In TAT software for flat beam floor structure, in the absence of beams and columns are linked together, usually we must, in accordance with the norms of simplifying the board such as two-way generation of frame beams are calculated. Therefore, in the case of the interactive modeling of the non-beam floor with the P MCAD, we should first determine the width and height of the beam, and the stiffness of the beam. Generally speaking, the stiffness of the beam is determined by the width of the plate: the width