热流道浇注系统(国外英文资料).docVIP

热流道浇注系统(国外英文资料) The hot runner system is also called a non-negotiable coagulation system, which requires an adiabatic or heated method in the injection mould The plastic in this passage from the nozzle to the cavity entrance is in a molten state, so it needs to be made by 111 when the die is open The r6f2 is required to take the coagulation of the mountain pouring system. The advantages and disadvantages and applicability of the 5.3.1 heat flow path forming The advantages of hot runner forming are as follows: (1) improves the quality of products. When the large plastic products are sprue gate, the residual stress of the gate is applied The deformation will bring a good effect on the physical properties and precision of the products, and therefore have to be used more than one. The point of the gate is water It is necessary to adopt the two plate mould structure, and the two plate structure should be avoided for large moulds. None of them can be formed To improve the quality of the products, AVX avoids the use of three-plate horizontal tools. (2) the consumption of raw materials has been reduced by the circulation of the village. (3) the requirement for the use of the injection machine is reduced by means of the second subtype. (4) automatic operation is easy to implement, and the follow-on anding of products decreases. The disadvantages of hot flow forming are as follows: (1) the design and maintenance of the module is difficult, and if there is no high level of mould and maintenance management, there is a variety of die and die in the production The fault. (2) when it is difficult to prepare, the director and model cost is high, and small batch production is not very effective. (3) there are restrictions on the shape of the products and the plastic. (4) it is very difficult to adopt the hot runner molding technique in the multiform. Thermal flow forming principle: far away from the plastic products of high speed, if the product has a long cooling time. . The plast