管道支架基础平衡计算法(国外英文资料).docVIP

管道支架基础平衡计算法(国外英文资料) The pressure can be calculated according to the following formula (4) (5) (6) (7) When ex or ey has a zero, the upper form can be computed by a one-way bias. Figure 3 (2) when the base area compressive area is in the shape of a pentagon (figure 4), the following formula can be used to calculate the pressure: Table 3 alpha, alpha, xi 1, xi 2, eta 1, eta 2 coefficients Note: the area under pressure is the quadrilateral coefficient xi 1, xi 2, (eta 1, eta 2). The area under pressure is the pentagonal coefficient xi2, eta 2; The area under pressure is alpha, alpha (4) (8) (9) (3) when the base area compressive area is a quadrangle (figure 5), the pressure is calculated according to the following formula: (5) P1 = pmax xi 2 / xi 1 (10) P2 = pmax eta 2 / eta 1 (11) When xi 2 = xi 1, or eta 2 = eta 1, the upper form can be calculated by the partial centricity. Type A, B - base plate size; Alpha, alpha, xi 1, xi 2, eta 1, eta 2 - as ex/A and ey/B are reviewed by the literature [2], 10 ~ 11. Ex, ey - eccentricity, calculate the following: Ex = Mx/N ey = My/N (12), (13) Mx, My - base surface along the x direction and y direction design values; N - the design value of the vertical load on the base of the base (including the foundation and the top soil weight); [R] - the allowable capacity of ground soil (kN/m2) by base width and buried deep correction. P1, p2, pmax - the pressure at each corner of the base area (including the base and upper soil weight) (kN/m2). Figure 4. Third, basic strength calculation Basic assumptions The strength of the base plate is calculated by the following assumption, when the eccentricity of the bidirectional eccentricity is eccentricity e A / 6. (1) regardless of the graph of the pressure zone, the foundation force acting on the bottom board is carried by four independent cantilever plates; Figure (2) the pressure value can be get based edge parallel to the axis of symmetry and online, the average pressure on the average reac