STM8S105K4烧录操作指南.pdf

CHiPAV Technology Application note ST-LINK/V2 烧录器使用简介 Revision History Date Version Author Comments 2013-11-25 DRAFT SW Group 2013-11-26 Ver1.0 SW Group Add hardware install issue. Information in this document is subject to change without notice and does not represent a commitment on the part of the manufacturer. The software described in this document is furnished under license agreement or nondisclosure agreement and may be used or copied only in accordance with the terms of the agreement. It is against the law to copy the software on any medium except as specifically allowed in the license or nondisclosure agreement. The purchaser may make one copy of the software for backup purposes. No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying, recording, or information storage and retrieval systems, for any purpose other than for the purchaser’s personal use, without written permission. Copyright © 2009-2013 CHiPAV Technology Co., Ltd. All rights reserved. CHiPAV Technology 1. 准备 a) ST-Link/V2 烧录器及其驱动（可用于 WIN XP ，WIN7 32/64 位操作系统）； b) 烧录工具软件，ST Visual Programmer （可到ST 官网免费下载，约 80M 大小）； c) 目标文件，烧录程序文件后缀为“.s19”； 2. ST-LINK/V2 烧录器 a) ST-LINK/V2，实物正反面照片如图 1、图2 所示： 图 1 正面图 图 2 背面图 b) 将 ST-LINK/V2 通过 USB 转接线与电脑连接，这时电脑会自动完成驱动的安装，请提 前准备好相关驱动，ST-LINK/V2 驱动可以用于 WIN XP ，WIN7 32/64 位操作系统。 注：ST-LINK/V2 的烧录器引脚说明： 如图 3 所示，自左向右，共 4 根 PIN ，分